Latest updates Cisco CCDP 300-115 dumps and pdf, 300-115 Practice Questions and Answers


Posted On Jul 10 2019 by
cisco study

Easily get the latest Cisco CCDP 300-115 dumps, “Implementing Cisco IP Switched Networks (SWITCH)” 300-115 Exam. You can upgrade your skills by downloading the 300-115 pdf or the online 300-115 exam exercise test! 99.5% pass rate:leads4pass.com

Table of Contents:

Latest Nicky Cisco CCDP 300-115 pdf

[PDF] Free Cisco CCDP 300-115 pdf dumps download from Google Drive: https://drive.google.com/open?id=1W4y0zB1TTjYPaoSt_iCuZ2D7lge3Bg3W

300-115 SWITCH – Cisco: https://www.cisco.com/c/en/us/training-events/training-certifications/exams/current-list/switch2.html

Latest Cisco CCDP 300-115 Practice Questions and Answers

QUESTION 1
Refer to the exhibit. Based upon the output of show VLAN on switch CAT2, what can we conclude about interfaces
Fa0/13 and Fa0/14?lead4pass 300-115 exam question q1

A. That interfaces Fa0/13 and Fa0/14 are in VLAN 1
B. That interfaces Fa0/13 and Fa0/14 are down
C. That interfaces Fa0/13 and Fa0/14 are trunk interfaces
D. That interfaces Fa0/13 and Fa0/14 have a domain mismatch with another switch
E. That interfaces Fa0/13 and Fa0/14 have a duplex mismatch with another switch
Correct Answer: C

 

QUESTION 2
How can you set VLAN 99 on a trunk to become a native VLAN?
A. switch port trunk native VLAN 99
B. switch port trunk VLAN 99 native
C. switchport native VLAN 99 trunk
D. switchport native trunk VLAN 99
E. switch port VLAN 99 native
F. switch port VLAN native trunk 99
Correct Answer: A


QUESTION 3
Routers R1 and R2 are configured for HSRP as shown below: Router R1: interface ethernet 0 IP address 20.6.2.1
255.255.255.0 standby 35 ip 20.6.2.21 standby 35 priority 100 interface ethernet 1 IP address 20.6.1.1.2 255.255.255.0
standby 34 ip 20.6.1.21
Router R2: interface ethernet 0 IP address 20.6.2.2 255.255.255.0 standby 35 ip 20.6.2.21 interface ethernet 1 IP
address 20.6.1.1.1 255.255.255.0 standby 34 ip 20.6.1.21 standby 34 priority 100 You have configured the routers R1
and R2 with HSRP. While debugging router R2 you notice very frequent HSRP group state transitions. What are the most
likely cause of this?
A. physical layer issues
B. no spanning tree loops
C. use of non-default HSRP timers
D. failure to set the command standby 35 preempt
Correct Answer: A

QUESTION 4
A network engineer notices inconsistent Cisco Discovery Protocol neighbors according to the diagram that is provided.
The engineer notices only a single neighbor that uses Cisco Discovery Protocol, but it has several routing neighbor
relationships. What would cause the output to show only the single neighbor?
A. The routers are connected via a Layer 2 switch.
B. IP routing is disabled on neighboring devices.
C. Cisco Express Forwarding is enabled locally.
D. Cisco Discovery Protocol advertisements are inconsistent between the local and remote devices.
Correct Answer: A
If all of the routers are connected to each other using a layer 2 switch, then each router will only have the single switch
port that it connects to as its neighbor. Even though multiple routing neighbors can be formed over a layer 2 network,
only the physical port that it connects to will be seen as a CDP neighbor. CDP can be used to determine the physical
topology, but not necessarily the logical topology.

QUESTION 5
Which three characteristics of AAA with TACACS+ are true? (Choose three.)
A. It runs on UDP port 1812
B. It is a standards-based implementation.
C. It uses a client-server architecture.
D. It is a Cisco-proprietary implementation.
E. It runs on TCP port 49.
F. It uses client-private cloud architecture.
Correct Answer: ABC

QUESTION 6
Which two statements about the LACP port priority of a device are true? (Choose two.)
A. To manually configure a link with an EtherChannel to come up first, set its lacp port-priority value lower than the
default.
B. It determines which links in an EtherChannel group are active.
C. To manually configure uses the port a link within an EtherChannel to come up first, set its lacp port- priority value
higher than the default.
D. The system uses the port priority of the local and remote device to determine which links in an EtherChannel group
are hot-standby.
E. LACP port-priority is used in the hashing algorithm to load-balance links within an EtherChannel.
F. The system uses the port priority of the local and remote devices to determine which links in an EtherChannel group
are active.
Correct Answer: AB

QUESTION 7
A workstation technician moves a PC from one office desk to another. Before the move, the PC has network connectivity
After the move as the PC plugged into the now network port, it loses network connectivity and the network switch port becomes err-disabled.
Which option can cause the Issue?
A. wrong VLAN
B. wrong switch port mode
C. port security
D. speed issue
Correct Answer: C


QUESTION 8
A network engineer notices inconsistent Cisco Discovery Protocol neighbors according to the diagram that is provided.
The engineer notices only a single neighbor that uses Cisco Discovery Protocol, but it has several routing neighbor
relationships. What would cause the output to show only the single neighbor?
A. The routers are connected via a Layer 2 switch.
B. IP routing is disabled on neighboring devices.
C. Cisco Express Forwarding is enabled locally.
D. Cisco Discovery Protocol advertisements are inconsistent between the local and remote devices.
Correct Answer: A
If all of the routers are connected to each other using a layer 2 switch, then each router will only have the single switch
port that it connects to as its neighbor. Even though multiple routing neighbors can be formed over a layer 2 network,
only the physical port that it connects to will be seen as a CDP neighbor. CDP can be used to determine the physical
topology, but not necessarily the logical topology.

QUESTION 9
A question about root path election.
A. interface bandwidth
B. load
C. reliability
D. interface usage
Correct Answer: A


QUESTION 10
Which feature prevents a newly-added switch from becoming the primary?
A. BPDU filtering
B. root guard
C. loop guard
D. BPDU guard
Correct Answer: B

QUESTION 11
Which two statements about VRRP are true? (Choose two.)
A. Authentication commands must be entered under the interface.
B. It sends advertisements to multicast address 224.0.0.9.
C. It supports MD5 and IP sec authentication.
D. It can use an interface IP address as the virtual IP address.
E. It sends advertisements to multicast address 224.0.0.18.
F. It is a Cisco proprietary protocol
Correct Answer: AE

QUESTION 12
What is possible EtherChannel load balancing mechanism based on layer 3?
A. Mac source
B. Mac source-destination
C. Ip Source
D. IP Source-destination
E. Mac destination
Correct Answer: CD

QUESTION 13
A question about UDLD. It shows a picture of 7 times and UDLD is set to aggressive mode. The port is set to shutdown
error-disabled.
A. The port is set to shut down because UDLD is set to aggressive mode.
B. The port is set to shut down because of STP…
C. https://www.certbus.com/300-115.html
D. https://www.certbus.com/300-115.html
Correct Answer: A

Latest Cisco CCDP 300-115 YouTube videos:

We offer more ways to make it easier for everyone to learn, and YouTube is the best tool in the video. Follow channels: https://www.youtube.com/channel/UCXg-xz6fddo6wo1Or9eHdIQ/videos get more useful exam content.

All of our exam dumps are updated throughout the year, follow us! Get the latest recommendations! Pass the Cisco CCDP 300-115 exam We recommend: https://www.leads4pass.com/300-115.html (1067 Q&A).

Related 300-115 Popular Exam resources

titlepdf youtube 300-115 SWITCH – Cisco lead4pass Lead4Pass Total Questions
Cisco 300-115 lead4pass 300-115 dumps pdf lead4pass 300-115 youtube 300-115 SWITCH – Cisco https://www.leads4pass.com/300-115.html 1067 Q&A
Cisco CCDP https://www.leads4pass.com/300-101.html 854 Q&A
https://www.leads4pass.com/300-320.html 670 Q&A
https://www.leads4pass.com/642-871.html 201 Q&A
https://www.leads4pass.com/642-873.html 140 Q&A
https://www.leads4pass.com/642-874.html 162 Q&A

Lead4pass Promo Code 12% Off

lead4pass 300-115 dumps

Why Choose Lead4pass?

Lead4Pass helps you pass the exam easily! We compare data from all websites in the network, other sites are expensive, and the data is not up to date, Lead4pass updates data throughout the year. The pass rate of the exam is above 98.9%.

why lead4pass 300-115 exam dumps

Last Updated on: July 10th, 2019 at 9:27 am, by admin


Written by admin